FYP2-Week 14

Title: Presentation


 for the last week i was attend to dewan gemilang to present my final year project.  My assessor are sir kamalulfaizin bin mohd suhut and mdm lili..alhamdulillah i got top 20 for my project...:)

FYP 2-WEEK 13

Title: Interfacing and prepare for presentation

For this week i start doing the preparation for the presentation that will be held on 9 november 2012. I have discuss with my supervisor to just use hearing aids without arduino because some problem during interfacing between both circuit. So that i make new model for my project

example for poster:

FYP2-Week 12

Objective : fyp briefing

1.Week 12,we attend last fyp briefing.Information from briefing We must upload document sheet for final project.Our demo is 20% from accessor.
For demo final year project diploma and degree sem 2 is 9 november 2012.
Our report must be submit in november 2012.

2.we prepare for slide presentation for our project.Must include objective project.


3.still progress our project.For make sure can run and function.

4.we have make draft for poster Final year project.Still waiting guideline from RPS.bmi.edu.

FYP2-Week 11

Objective : Constract ardunio circuit

after done 2 design this circuit n completer hearing aids circuit..i start to constract arduino circuit
1-iron the circuit on pcb board
2-itching pcb by using acid
3-circuit after itchning
4- clean the circuit using thinner
5- drill the circuit to make hole
6-soldier all commponent
7-complete circuit

FYP2-Week 10

objective : Calibrate the circuit
after done contract the circuit..in this week i will test and calibrate the circuit whether it functioning or not.

check all connection of component..to check all connection i have use multimeter..

FYP2-Week 8

Objective:  Hearing aid circuit on pcb board
for this week,after i done design the circuit i start to attach the circuit on PCB board

1-print the circuit on sticker paper
2-attach on PCB board
3.iron n remove the sticker paper
4.etching the circuit

FYP2-Week 9

Objective: continue to construct circuit

for this week i continue to design the circuit with constarct it..
1.Drill the circuit to make hole for all component.
2-Saw the board to be compact circuit
3- soldier all component to PCB board